Adhesive paste on the ground under the superhard fiberboard should be applied stripes width of 100-200 mm on the perimeter boards in the neutral zone with an interval of 300-400 mm. If you have additional questions, you may want to visit FERI. When the layout and prirezke fibreboard jointing four corners of the plates at one point not .Tehnicheskie requirements for installing parquet coatings lag Specifications Tolerances Control (method, amount, type of registration) All logs, boards (except the front side), wood strips are laid on the column under the joists, and wood under base fiber boards should be antiseptirovany Visual, all materials, inspection certificate of the hidden works Humidity materials should not exceed for: lag and 18 Test strips for at least three measurements for every 50-70 square meters. m above the floor, journal papers and boards cover the base with their installation in 1912 and inlaid parquet, parquet and parquet panels 10 hardboard cover 12 Length abutting lag should not be less than 2 m thick log, based on the entire lower surface of slabs or soundproof layer – 40 mm, width – 80-100 mm. The thickness of the log to be placed on separate supports (columns in the floor on the ground, floor beams, etc.) should be 40-50 mm, width – 100-120 mm – measuring at least three measurements for every 50-70 square meters. m above the floor, the magazine made wooden strips under the joists in the floors on the ground: the width of -100-150 mm, length – 200-250 mm, thickness – not less than 25 mm – Measuring at least three measurements for every 50-70 square meters. m above the floor, the magazine works Wheelbase log, stacked on the floor slabs and floor beams (at the surface was laid directly on the beams) should be be 0,4-0,5 m! When installing the lag on separate supports (columns in the floor on the ground, floor beams, etc.), this distance should be: at a thickness of 40 mm lag – 0,8-0,9 m with a thickness of 50 mm lag – 1,0-1, 1 meter – measuring at least three measurements for every 50-70 square meters.
m the floor, the magazine works length abutting ends of boards covering must be at least 2 m, and the parquet – not less than 1,2 m – measuring at least three measurements for every 50-70 square meters. mpoverhnosti sex, the magazine works thickness of adhesive layer under the dial and the parquet and superhard fibreboard shall be no more than 1 mm – measuring at least five measurements for every 50-70 square meters. m above the floor or in one room, a smaller area, the magazine work area gluing: floor plank – no less than 80%, fibreboard – at least 40% – Technical, with a trial show of products in at least three places to 500 square meters. m above the floor, the magazine works